Moisture Resistance Treatment Solution 712-025 6ML/ Bottle

Transbond Photocuring Orthodontic Pretreatment712-034

MIP Moisture Resistance Treatment Solution 712-025

Model：712-034/712-025

6ml/ bottle

Product Introduction

Model number: 712-025

ingredients:
bisphenol A diglycopyl methacrylate, dilight ethyl methacrylate product
performance: orthodontic preconditioning agent for liquid (transparent
or colored) clarify, uniform texture, no visible impurities: shear
bonding strength is not less than 6MPa; It is thermally stable.

Application：

This product is used for pre-bonding treatment of orthodontic treatment.

Use：

Tooth surface preparation

1. Pretreat teeth with oil-free pumice stone or paste and rinse with water. Use cotton rolls to isolate teeth Dry thoroughly

2. Apply Transbondm xT etching agent to the surface of teeth according to the instruction for etching agent.

3. Rinse the etching agent with water, Remove excess water, but do not need to blow dry.

Note: In order to ensure the best results, please strictly follow the following operations.

4. Place three drops of Transbond™ MIP moisture resistant preconditioning agent, close the cap tightly to prevent leakage.

5.
Dip the brush head and saturate it completely , Apply a thin layer to
the acid-eroded tooth surface, avoiding contact with the gum area.

6. Gently blow each tooth with an air gun for 2-5 seconds, noting that the air flow is perpendicular to the lip of the tooth .

Adhesive

TransbondTM
MIP moisture resistant preconditioning can be combined with the
following light curing adhesive products: APC Preset Adhesive Orthotic
System, TransbondTM XT light curing adhesive.